Garage Door Cable Repair in Manor, TX | Garage Door USA
from $149
Garage Door Garage Door Cable Repair Manor, TX
Lift-cable replacement, drum re-spooling, and tension recalibration. We pair new cables with a spring inspection so the door is safe and balanced before we leave.
We run garage door cable repair across Harris Branch and the surrounding Manor area and the wider Travis County area — quick turnaround when you call early, flat-rate always, and guaranteed for ten years.
Because Manor has a warm, humid climate of sultry summers, abundant rainfall, and damp conditions that work hard on metal hardware, the doors here age differently than inland or coastal homes elsewhere. The usual culprits are damp garages that pit galvanized parts over time, salt-tinged coastal air that accelerates rust near the shore, and high year-round humidity that rusts springs, cables, and fasteners — exactly what our techs come prepared for.
We've fixed thousands of doors around Travis County, and the pattern holds in Manor: corroded springs and cables in the humid air, moisture-tripped openers and sensors after storms, degraded weatherstripping from UV and moisture, and storm-driven debris and water in the tracks. None of it should leave you without a working garage for more than a day.
Lift cables transfer the spring's stored energy to the door panels — they're under high tension every cycle and degrade slowly through fraying, corrosion, and mis-spooling on the drum. A cable repair visit replaces both cables (always replace as a pair so the door stays balanced), re-spools the drums to the correct number of wraps, recalibrates spring tension to match, and inspects related components like the bottom bracket where one end of each cable terminates.
Cables are galvanized aircraft-grade steel — typically 1/8-inch diameter for residential doors and 3/16-inch for heavier or commercial doors. We carry both diameters along with the bottom-bracket fittings, drum caps, and shaft set-screws that occasionally need replacement alongside the cables.
Cable failure usually leaves the door off-track or hanging crooked. Continuing to operate the opener after one cable has snapped causes the other side to take the full load and is the fastest way to bend tracks or damage panels. Stop the opener and call for repair when you see a frayed or snapped cable — fast service is standard.
Strands of steel poking out of the cable indicate active wear. Cables don't self-heal — frays accelerate to snap.
Door hangs crooked when closed
If one corner is higher than the other when the door is fully down, one cable has stretched, slipped on the drum, or partially failed.
Snapped cable, door stuck
A fully snapped cable leaves the door off-track or jammed. Don't try to force it — call for repair.
Rust streaks on cables
Coastal homes see cable corrosion progress until the strands weaken. Visible rust means the cable is no longer at full strength.
Loud bang followed by crooked door
Cable snap sounds similar to spring snap but is usually quieter. If the door is crooked after the noise, suspect cable failure.
Common causes & what we fix
Mis-spooled drum
When a cable jumps off its drum groove, it crosses over itself and wears at the crossover point. Re-spooling fixes the spool but the wear point becomes the weak link.
Drum cap or set-screw failure
If the drum slips on the shaft, one cable unwinds while the other tries to hold. This sudden imbalance can snap the loaded cable.
Bottom bracket failure
The bracket where the cable attaches at the door bottom occasionally cracks or pulls free, letting the cable whip free under tension.
Coastal corrosion
Salt-air pitting on uncoated cables can drop tensile strength 30–40% over 10+ years. Galvanized aircraft cables resist this far better.
Spring imbalance
An over- or under-tensioned spring puts uneven load on the cables and accelerates wear on the loaded side.
Our process
1
Call or schedule online. Start your garage door cable repair request by phone or online. Pick a 2-hour window; a five-minute confirmation follows with the tech's name and photo.
2
On-site diagnosis. On-site, we pinpoint the garage door cable repair fault and show it to you. Diagnosis is free for most repairs and $39 for minor service calls — waived the moment you proceed.
3
Flat-rate quote. Before starting, we hand you a written, flat-rate garage door cable repair estimate. What you see is what you pay — no hourly surprises, no commission-driven add-ons.
4
Same-visit fix. Nine times in ten — 96%, really — the garage door cable repair is done in one visit. You watch the final test cycle, and we haul off every old part and bit of debris.
How much does garage door cable repair cost in Manor, TX?
What you'll pay for garage door cable repair in Manor, TX: a flat rate starting at $149, confirmed in writing up front. Senior, military, and financing options are all on the table, and the quote is good for a full 30 days. Pricing garage door cable repair cost in Manor, TX? The quote is flat-rate and in writing before any work begins — no hourly creep.
Garage Door Cable Repair the United States starts at from $149, and your garage door cable repair quote in Manor is flat-rate, in writing, and final before any work — no add-ons, no creeping hourly charges. Senior (65+) and military customers get 10% off labor, and Synchrony funds projects above $1,500 at 0% APR for a year with no prepayment penalty.
Why homeowners in Manor, TX choose us for garage door cable repair
For garage door cable repair, Manor keeps calling because we show up on time and finish in one trip 96% of the time. Licensed (CSLB #1098234), insured, and accountable to Travis County. For professional garage door cable repair in Manor, TX, Manor homeowners reach a salaried, background-checked crew, never a call center.
Your garage door cable repair in Manor is covered by a 10-year workmanship guarantee — distinct from any parts warranty the manufacturer provides. If our garage door cable repair fails on us, we fix it free for a decade. Springs built for 30,000 cycles carry a lifetime warranty for the original homeowner, and remaining parts run standard 1–5 year coverage.
The two rules behind every garage door cable repair quote: don't sell work that isn't needed, and show the customer everything. Our salaried techs have no commission incentive, the diagnostic is fully transparent, and we call repair-versus-replace on the long-term math, not the bigger ticket. Your flat-rate garage door cable repair quote is written and good for 30 days.
Areas we serve for garage door cable repair
We provide garage door cable repair throughout Manor, TX and the surrounding Travis County area. Serving Harris Branch and surrounding neighborhoods.
We run garage door cable repair across Travis County end to end — Travis County is part of Texas. Manor sits right in it, alongside Elgin, Pflugerville, Hornsby Bend, and Wells Branch.
From Manor our garage door cable repair extends to Elgin, Pflugerville, Hornsby Bend, and Wells Branch, covering the in-between neighborhoods most one-truck shops skip. Local garage door cable repair in Manor, TX and ZIP 78653 — same crew, same flat rate, no travel surcharge for the edges of town.
Garage Door Cable Repair near you in Manor, TX
Plenty of results for "garage door cable repair near me" in Manor are out-of-area middlemen. We aren't: our trucks already run Harris Branch and the surrounding Manor area, so being close keeps both the wait and the price honest.
Manor is part of our greater Austin, TX metro service area.
We service ZIP codes 78653 and everything around them. Because Manor traffic moves garage door cable repair response times around, we quote your ETA live on the call rather than guessing. Our dispatch number connects to an on-call tech with no voicemail in the way. For local garage door cable repair in Manor, TX, including 78653, we route the nearest stocked truck straight to your door.
Frequently asked about garage door cable repair
Top questions homeowners searching for Garage Door Cable Repair near me ask us:
Yes. Travis County is part of Texas, and we work the whole footprint: Manor plus nearby Elgin, Pflugerville, Hornsby Bend, and Wells Branch. Same licensed, insured crews and 10-year workmanship guarantee county-wide.
The call we get most in Manor is corroded springs and cables in the humid air. Manor has mainly suburban houses with attached two-car garages, mixed with some older central-neighborhood homes, so moisture-tripped openers and sensors after storms turns up often too. We carry the common parts on the truck for a single-visit fix.
Most cable jobs run 45–60 minutes including spring tension verification and balance test. Add 15 minutes if drums also need replacement.
Cable repairs are quoted flat-rate before starting; the figure depends on whether the drums or a bottom bracket also need replacement. No surprises once you approve the written quote.
5 years on cables and drums. 10-year workmanship on the install. Galvanized cables in coastal homes typically last well beyond it.
No — running the opener with a failed cable bends tracks and risks the door coming off the rail entirely. Disconnect the opener and avoid using the door until repair.